Our PSAB2003 Bondloc Aqua Epoxy Putty Stick is a B2007 is a hand-mixable, speciality epoxy putty for repairs to damp, wet areas and underwater surfaces. After mixing, it forms a polymer compound that may be applied underwater (either fresh or salt water) and will bond tenaciously to substrates such as: fibreglass, concrete, ceramic, glass, metal, wood, and many plastics.
Each epoxy stick contains pre-measured portions of base and activator throughout no measuring or mixing tools are necessary.
The consistency (like modelling clay) eliminates drips and runs, facilitates adhesion to the substrate, and allows the material to be shaped and formed as needed before curing begins. After 60 minutes the application can be drilled, sawed, sanded, carved, and painted.
This Aqua Plastic Epoxy Putty Stick cures to off-white colour and is suitable for interior or exterior use as it is resistant to: chemicals, water, and temperature extremes.
PSAB2007 contains no solvents or VOC, and it is non-flammable, nor releases no noxious fumes. On top of that it won’t shrink or pull away, and the unused portion stays fresh for future use when saved in its original packaging.
Applications
This waterproof epoxy can be used to:
- Patch dings
- Holes
- Gouges
- Repair decks and hulls
- Pools hot tubs and spas
- Marine recreational equipment
- Leaking gaskets
- Gutters and tanks
- Pipes
- Leaking lead water outlets
- Epoxy putty for toilets
- Similar applications
This epoxy will also bond to:
- Fiberglass
- Metal
- Wood
- Concrete
- Glass
- Many plastics
PSAB2007 works on wet, damp, dry surfaces and underwater.
Instructions for use
In order to achieve optimum adhesion, the surface you are applying this epoxy to should be cleaned free of grease or dirt. Scuffing or sanding the surface prior to cleaning will also help to ensure a good bond.
Pinch off the required quantity of putty, and then knead the inner and outer layer together thoroughly until one consistent colour shade is achieved.
Technical information
| Property | Value |
|---|---|
| Resin | Off white |
| Chemical resistance | Hydrocarbons, Ketones, esters, halo-carbons, alcohols, aqueous salt solutions, dilute acids and bases |
| Electrical resistance | 30,000 mega Ohms |
| Dielectric strength (steel) | 300 Volts/mil |
| Shrinkage | <1% |
| Non-volatile content | 100% |
Cured performance
| Property | Value |
|---|---|
| Initial cure | 1 hour |
| Full cure time | 24 hours |
| Lap shear strength (steel) | 6.2 MPa |
| Shore D Hardness | 65 |
| Compressive strength | 1.9gm/cm |
Health & Safety Information
This adhesive contains epoxy resin and may cause skin irritation in sensitive individuals. Unnecessary skin contact should, therefore, be avoided. If skin contact occurs, wash with a proprietary hand cleaner, followed by washing with soap and water.
In case of eye contact, flush with clean water for at least 15 minutes, and then seek medical attention. When fully cured, the product can be considered non-toxic. Always keep this adhesive away from foodstuffs and food utensils.
Storage information
Store in cool conditions, preferably away from direct sunlight or excessive heat. Shelf life at least 24 months @ 24C.
Not sure if this aqua plastic epoxy is right for you?
If you are not sure if this adhesive is right for your individual requirements please do not hesitate to Contact our friendly sales team and we will be happy to help you.
Do you require a Certificate of Conformance and traceability?
If you require a Certificate of Conformance, please contact us after ordering (either by phone or email) and we will get this sent out to you with your order.
Reviews
There are no reviews yet