Our PSA6001A is a 50mm x 33 Metres Polyester Blanking Tape which is self adhesive tape commonly used to seal the ends of multi wall polycarbonate sheeting minimising the ingress of dust, debris and insects whilst allowing the escape of moisture vapour.
This blanking tape has a High performance adhesive system offering:
- High tack
- High adhesion
- Excellent elevated temperature performance
This adhesive tape is an industry approved adhesive providing UV stability and water resistance.
By nature, the fabric surface is water repellent and possesses excellent breathability over its open surface area.
The material has been manufactured from FDA approved materials and is suitable for extended skin contact.
Not sure if this tape is right for you, or require the Material Datasheet?
If you are not sure if this blanking tape is right for your individual requirements, please do not hesitate to contact our friendly sales team and we will be happy to help you.
Technical Details
| Adhesion | Value |
|---|---|
| Peel resistance (tested to steel) | 1200 N/M |
| Loop Tack | 1700 M/M |
| Shear | > 50 hours @ 1kg |
| Temperature range | Value |
|---|---|
| -20?C to 80?C | Continuous |
| -20?C to 80?C | Short term |
** results taken from British Board of Agr�ment Test Report No: 2534
Tensile strength and elongation
45mm test width
| Filtration information | Value |
|---|---|
| Max Load | 179.21 (N 50mm) � mean result ** |
| Strain at max load | 41.05 % – mean result ** |
| Water vapour transmission – Tested to BS 3177: 1959 (1995) | Mean permeability 4474 (gm�24h) ** |
Thermal shock / condensation
In accordance with MOAT 48 : 1991
This test procedure is intended to replicate the ability of the blanking tape to resist the passage of water and therefore the formation of condensation within the cavities of the polycarbonate under wet/heat cycling conditions
Cycle 0-25 no leaks or condensation **
Cycle 25-50 no leaks or condensation **
Resistance to penetration by particulates
Filter cut point 45 microns (rounded up to the nearest 5mic) **
The above information is given in good faith and for guidance only. The user shall be responsible for determining that the performance of the product is sufficient for his application. The quoted values are based on averages and should not be taken as maximum or minimum values for specific purposes.
Composition
Polyester / Polypropylene, Thermoplastic Rubber Adhesive with UV inhibitor. Tissue and Release liner No Hazardous components
Labelling
No mandatory labelling is required.
Health information
Under normal conditions of use and handling no hazards are anticipated but good hygiene should always be observed. No special protection is required. If skin irritation occurs as a result of handling, wash affected areas with soap and water and wear protective clothing to avoid future contact.
Fire Fighting Measures
Fire extinguishing media � Foam, dry chemical, or water.
Handling and Storage
Store at room temprature.
Physical and Chemical Properties
Physical state: Solid.
Stability and Reactivity
Stability: Stable
Toxicological Information
Not applicable
Transport Information
No special handling required.
Do you require a Certificate of Conformance and traceability?
If you require a Certificate of Conformance, please contact us after ordering (either by phone or email) and we will get this sent out to you with your order.
Reviews
There are no reviews yet